TABLE OF CONTENT PAGES
TITLE PAGE……………………………………………………………………………………………..i
CERTIFICATION……………………………………………………………………………………..ii
DEDICATION…………………………………………………………………………………………..iii
ACKNOWLEDGEMENT……………………………………………………………………………..iv
ABSTRACT………………………………………………………………………………………………v
TABLE OF CONTENT…………………………………………………………………………….vi-vii
LISTS OF FIGURES……………………………………………………………………………….viii-ix
CHAPTER ONE
1.0 INTRODUCTION……………………………………………………………………………….1
1.1 PROJECT OBJECTIVE…………………………………………………………………………2
1.2 SCOPE OF THE PROJECT……………………………………………………………………….3
1.3 OPERATION OF THE SYSTEM…………………………………………………………..4
1.4 ARCHTECTURE OF THE SYSTEM…………………………………………………………5
CHAPTER TWO
2. 0 LITERURE REVIEW……………………………………………………………………………..6
2.1 SYSTEM DESCRIPTION…………………………………………………………………………7
7
2.1.1 USER GSM MOBILE HANDSET……………………………………………………….8-11
2.1.2 RECEIVER GSM HANDSET…………………………………………………………..12-13
2.2 MICROCONTROLLER BOARD……………………………………………………………..14
2.3 SWITCHING MODULE……………………………………………………………………….15
CHAPTER THREE
3.0 SOFTWARE DESIGNING…………………………………………………………………….16
3.1 TRANSFORMER……………………………………………………………………………17-19
3.2 TRANSFORMER CALCULATION……………………………………………………….20-26
3.3 RECTIFICATION PROCESS………………………………………………………………27-30
3.4 MICROCONTROLLER SECTION……………………………………………………….31 -35
CHAPTER FOUR
4.0 TESTING…………………………………………………………………………………………..36
4.1 SYSTEM TESTING………………………………………………………………………………37
4.2 PACKAGING……………………………………………………………………………………..38
4.3 TROUBLE SHOOTING THE DESIGN………………………………………………………39
8
CHAPTER FIVE
5.0 PROBLEM ENCOUNTERED……………………………………………………………….40
5.1 PRECAUTIONS………………………………………………………………………………….41
5.2 RECOMMENDATION………………………………………………………………………..42
5.3 CONCLUSION…………………………………………………………………………………..43
5.5 APPENDIX……………………………………………………………………………………….44
5.4 PROGRAMME CODES……………………………………………………………………45-55
5.6 REFERENCE………………………………………………………………………………………56
9
ABSTRACT
The advantage of cellular communication like GSM technology is a potential
solution for such remote controlling activities. GSM-SMS technology can be used
to control household appliances from remote places. Remotely, the system
allows the home owner to monitor and control his house appliances via his
mobile phone set by sending commands in the form of SMS message and
receiving the appliances status as well. This system provides ideal solution to the
problems caused in situations when a wired connection between a remote
appliance device and the control unit might not be feasible. The system is
wireless and uses the user’s mobile handset for control and therefore the
system is more adaptable and cost effective. The system uses GSM technology
thus providing ubiquitous access to the system for appliance control. With this
hypothesis, three different approaches have been proposed and implemented
in this project; FIRSTLY, home control switch/household appliances are
controlled by server mobile which acts as remote control. SECONDLY, GSM-SMS
messaging technology is used to control them from remote places and FINALLY,
to provide a multiple agents environment.
10
CHAPTER ONE
INTRODUCTION
Nowadays, people’s expectations in their life quality are increasing as the
technology is improving rapidly. People need an affordable system (smart) that
can make their lives easier, more comfortable, and offer more safety.GSM based
home automation system is an electrical and electronic system designed to
control home appliance with a mobile phone. The two main technologies
applied in the system are GSM and PLC. GSM stands for global system for mobile
communication and PLC stands for power line communication. In this study,
Nokia 6100 is chosen as the GSM phone that receives command and transfers it
to controller. Due to rapidly advancing of mobile communication technology and
widely availability make it possible to incorporate mobile technology into home
automation systems. ’’AT’’ command is used as communication between GSM
phone and microcontroller by passing through a serial interface RS232 with the
help of its driver.
The project is based on the principle of GSM network, which enables the
user to remotely control the operations of the appliances by using a mobile
phone. In other word it would transform a normal home into an intelligent
home. The controlling circuit is the most important component in
communication and interface between home appliances. It was implemented by
11
using peripheral interface controller (PIC) interfaced to mobile phone. The user
can perform ON/OFF operations of the appliances just by pressing keypad of
mobile phone.
The user sends GSM data in the form of SMS (short message service) message
to switch ON or OFF any appliances at home such as lamp, air condition, fan and
etc. the appliances may also provide the user with its current ON/OFF status.
The system can be improved to provide the user with information about the
status of each appliance.
PROJECT OBJECTIVES
The objectives of this project are as follows;
1. To design and develop home appliances control system over GSM
network by using a mobile phone.
2. To determine and understand on how the GSM works.
3. To understand the architecture and programming of the PIC.
4. To learn the troubleshooting and techniques.
12
SCOPE OF THE PROJECT
The scopes of works in this project are;
1. Mobile phone with SIM card enables the user to remotely control the
operations of the appliances by communication to the GSM modem.
2. GSM modem allows the capability to send and receive SMS to and from
the mobile phone.
3. RS-232 is the basic serial communication cable that will be used to
interface between GSM modem and PIC microcontroller.
4. PIC microcontroller will be interfaced to the control circuit that is
connected to the appliances. It contains the software components
through which the appliances are controlled and monitored.
5. Relay and control circuit used to detect and control the condition of the
home appliances.
OPERATION OF THE SYSTEM
The system works as a remote sensing for the electrical appliances at home or
industry to check whether it is ON or OFF, at the same time the user can control
the electrical appliances at home by sending SMS message into the system, for
example, turning on the AC before returning home. in case of fire/security the
chip will receive signals from the different sensors in the monitoring place and
13
acts according to the received signal by sending an SMS message to user’s
mobile phone, it also works as automatic and immediate reporting to the user
in case of emergency for home security, as well as immediate and automatic
reporting to the fire brigade and police station according to activated sensor to
decrease the time required for tracking action.
A sketch of overall design of the home appliances control using GSM is shown
in the figure below.
RS232 interface
Relay interface
FIG; Simplified block diagram of home appliances
Control using GSM.
ARCHTECTURE OF THE SYSTEM
It can be implemented to any levels of the security system. The architecture of
the system mainly consists of three components the GSM MODEM and the
Mobile
device
(user) GSM
modem
PIC
Home
appliances
14
interface circuit that include the different sensors used. The function of the GSM
MODEM is the remote communication between the user and the controller
through the RS232 serial communication standard. The function of the
controller is to continuously check the inputs coming from the different sensor
and send message through the GSM network in case of emergency such that it
acts as a 24hours monitoring and continuously checking for any received
message from the user through the GSM MODEM to switch on the AC for
example
DISCLAIMER: All project works, files and documents posted on this website, eProjectTopics.com are the property/copyright of their respective owners. They are for research reference/guidance purposes only and some of the works may be crowd-sourced. Please don’t submit someone’s work as your own to avoid plagiarism and its consequences. Use it as a reference/citation/guidance purpose only and not copy the work word for word (verbatim). The paper should be used as a guide or framework for your own paper. The contents of this paper should be able to help you in generating new ideas and thoughts for your own study. eProjectTopics.com is a repository of research works where works are uploaded for research guidance. Our aim of providing this work is to help you eradicate the stress of going from one school library to another in search of research materials. This is a legal service because all tertiary institutions permit their students to read previous works, projects, books, articles, journals or papers while developing their own works. This is where the need for literature review comes in. “What a good artist understands is that nothing comes from nowhere. The paid subscription on eProjectTopics.com is a means by which the website is maintained to support Open Education. If you see your work posted here by any means, and you want it to be removed/credited, please contact us with the web address link to the work. We will reply to and honour every request. Please notice it may take up to 24 – 48 hours to process your request.
