Page Length: 53

Size: 113 KB

Format: PDF & Word

5,000.00

Abstract

Basically, it can be discovered that there are heaps of files, available space in the office of the Head of  Computer  Science Department, slowing down his or her work, making the place untidy and even frightening him  from tasks  to be accomplished, but it should not be so in this era or period of paperless office brought in the use of  computer system.  Firstly, I have taken the share of untidiness by developing designing and application packaging that would aid him is allocation of course to the different programs that are offered  at the department. Consequently, my project is restricted  40  course allocation their time table where research show  that some course are allocated on the first semester and  second semester respectively depending  on the program  whether morning or  evening. The electronic document management system (EDMS) is ideal for voluminous data such as those found on the office of the Head of Department computer Science, Abia State Polytechnic, Aba, that is where this research work  is embarked on as  the case study.

 

 

Table Of Contents

Tile page

Approval page

Certification

Dedication

Acknowledgment

Abstract

Table of Contents

CHAPTER  ONE: INTRODUCTION

1.0       Introduction

1.1       Statement of the Problem

1.2       Objective of the   study

1.3       Significance of the study

14        Scope and limitation OF The study

1.5       Background of the Course  study

1.6       Definition of Terms

CHAPTER TWO:  LITERATURE REVIEW

2.0       Literature Review

CHAPTER THREE: RESEARCH METHODOLOGY, SYSTEM INVESTIGATION AN ANALYSIS

3.0       Research Methodology

3.1System Investigation

3.2       Observation Method

3.3       examinations of Report

3.4       System analysis

3.4       Method of data Analysis

3.07     Analysis of Findings

CHAPTER FOUR: SYSTEM DESIGN AND IMPLEMENTATION             

4.0       System Design

4.01     Output Design

4.02     Input Design

4.03     File Design

4.0 4    data Design

4.1       Proposal of the new System

4.2       Objective of the New System

4.2.1    Security of data

4.3.2    Accurate Information

4.2.2    Speedy operation on the Information File

4.2.3    High productivity Improved service

4.2.4    Economic use of resource

4.3       Hardware Requirements

4.4       Programming Flowchart

4.5       Software Requirements

4.6       Procedure for successful installation on allocation (automated)

4.6.1    File conversion

4.6.2    change-over procedure

4.6.3    Training

4.6.4    System Evaluation

4.6.5    Maintenance

CHAPTER FIVE: SUMMARY, CONCLUSION AND RECOMMENDATION

5.0       Summary

5.1       Conclusion

5.2       Recommendation

References

 

 

 

 

 

 

 

CHAPTER  ONE

 INTRODUCTION

  • Introduction

Over the years allocation of course  their credit units  and departmental timetable have been growing from one stage to another and similarly, the procedures and routine embarked   on  every semester coupled  with the departmental growth compounded the problem of manual  allocation of course  their units and thereby delays the registration procedures because some students  paying extra  fee as payment that is demanded in addition to the usual charge for registering  their  course  late, as late payment but computerization or  automation of course their credit  units allocation and departmental time provide the most effective reliable  and quickest services required  by the  students. Basically, before   the invention of computers, computation were  done manually  and in the case of the departmental course, their credit  units and departmental timetable, it  has caused accelerated progress especially  the automation of department  course  their credit units and departmental time table. Computer technology has been accepted as an  indispensable  innovation in most  fields of human endeavour  in which departmental courses is not an exception.

 

Hence, the efficiency of an organization  or establishment  would be achieved  if they embark on compute r-based  system. However, using the computer based system in place of the manual system, a charge that is going on in Abia State Polytechnic course registration procedure. It will make the practical insinuation of high technology. This will enframe the time needed  for processing of departmental course  and attend to other subsequent information needed by the management system. The important of this researcher is so prominent with the current of processing the departmental course and suggest a complete efficient and reliable  approach that will be of immense benefit  to most higher institutions in general especially to the state polytechnic Aba.

 

Actually, this would go a long way to improve  their  service by exposing and creating awareness of  computer applications.

 

1.1  Statement Of The Problem

Since  established  in  1992, Abia State  Polytechnic comprises of four schools among which is the school of  science  and Industrial Technology (SSIT which house  the department of  Computer Science and Statistics Department),  the  other schools have problems, One of which was late allocation of coursd and credit units  to enable the students finish their registration process  and  have  foresight of what the semester  would  look like. It was studied and discovered  that automation of departmental course  and the manual system  of allocation course, their credit  unit  usually waste a lot of time and papa even pen can be reduced  on the process of arranging it and also improve upon removing such problems. Below are some of the problems  in this system.

  1. It delays students registration process.
  2. It results to high cost of data processing each semester.
  3. it wastes much paper and make filling of form cumbersome
  4. It delays other departmental duties that are also important
  5. It results to inefficiency of course allocation.

 

Because of these set backs computer department i.e the case study has continued to  leave activities untended to  by the head of department because of volume  of work  left for him to do alone.

 

 

 

  • Objective of The Study

This project work has many aims and objectives to achieve, these aims are geared towards carrying investigations in the old course allocation  method  (manual) making us of computer department of Abia State  Polytechnic, Aba  as a cases study and giving a suggestions on how wtro improve staff under the department to the numerous students of the department.

 

Meanwhile, this wate-up would  also among or include all

  1. Designing a system that will be more interactive to  students and lecturers.,
  2. Provide an automatic system that will reduce the work load of staff especially the HODs
  3. The research will also serve as a soure of information to students, lecturers and computer science researchers who would want to engage  in such  topic “The Automation of Departmental  course their credit Unit  Allocation and departmental time table.
  4. Provide quicker  and more efficient services  (course allocation) using  automated system (computer).

 

1.3  Significance Of The Study  

Definitely, the complete implementation of this   work will be introduced as a trend in the present method of allocating  course their credit units and departmental time  table, the change would  in-doubt make   the management  and students happier, such changes  envisage will  include the following:

  1. The high cost incurred by the management in buying of papers, ,pens, pencils, makers, measuring  ruler  etc  , the clerical duties  involves in course  allocation and department  time table will be reduced drastically  because the hard  disk, floppies,  tape  would be used  instead of the above mentioned.
  2. The time involved in allocating and re-allocating which normally results to delay will be reduced.
  • Students would then utilize their time efficiently  during the registration of course.
  1. Automated System would also serve as a  reference  file for the students and staff since the course, credit   units time table and lectures in charge of all therefore then.
  2. The researcher work is also  significant  because  it is based on the award of Diploma  in Computer Science  to  the researcher however, its significant can only be envisaged  better when it is  implemented, evaluate, and  maintained  to be running in the computer, such as in  computer  Science Department, from where other departments can

 

 

1.4  Scope And  Limitation Of The Study

This  study is  aimed at finding out  how  the use of automated system can help  in course allocation in the computer science department of Abia state  polytechnic, Aba.

 

The study covered only the department of computer science due to some  limitations of the researcher to extend the research to other  departments within the school of science  and Industrial Technology (SSIT), let alone  other school  in the Institution, the constraints are as follows:

  • Finance: Fund or running around for the data required was in short supply and consequently hindered further research.
  • Time Constraints: Due to the required completion , time of this research work, it was not possible to extend the research to other departments.
  • Complexity: Meanwhile extending the research to all department within institution would lead to completion and complication resulting to un liability of research.
  • Cost: Feasibility cost conducting the research in all schools departments provide that it is not feasible for a single students (the researcher) to bear students can continue work on this research in future until

 

  • Background of The Course study

Abia  state  Polytechnic was  established by ediet number  of 8 of 1994 which  has a  retrospect effect from 2nd  October 1992. its  location is the former premises of Girls technical College (GTC) Aba,  along Aba Owerri Road Umungasi, Aba, Abia  State. The National Diploma  Progammes commenced  in 1994/1995  academic year  while Higher national Diploma  commence  in 1999/2000 Academic year.

 

It’s administration made it possible for it to comprise of four schools, they are as  follows:

  1. School of General studies and continuing Education (SBMT)
  2. School of Engineering Technology (SET)
  3. School of science and Industrial Technology (SSIT)

The schools are made up of Departments, which offers various National diploma (ND), Higher National diploma (HND) and diploma programmes respectively. The case study department of computer Science, a sub of schools of science and Industrial Technology offers various course leading to National Diploma programme to its  students. Hence, the case study is chosen so that any successful achievement records on this work (research) can easily be transferred to  their departments within the institutions, the  staff of the department comprise of the following.

  1. Direct of school (DOS)
  2. Head of Department (HOD)
  • Secretary
  1. Lecturers
  2. Chief Technologist
  3. Assistant technologist
  • Laboratory Attendants
  • Office Assistance (Messengers)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1.6  Definition Of Terms

In this chapter being the first chapter of this project work certain terms r elating to this research work which may  look very irrelevant  to some body  from other discipline  are defined  underneath.

  1. Automation: The conversion of manual system to machine (Computer) based system
  2. Computer: It is a machine mainly an electronic device which accepts the data as an input, process the data and generate the result as an output.
  3. Credit Unit: This is the number of hour, practical or tutorial or allocated weeks in each semester.
  4. Head of Department: The “Head” as the name implies the controller of director even the person or body at the hem of affair in the
  5. Director of school: This is the  person that co-ordination each
  6. Technologist: This is the technological craft man that can dissemble  and re-assemble any  technical device  or machine.
  7. Course: every  programme in each department  based  on arrangement in which course  are evaluated  in terms of credit  A course consists of a certain number of hours  of teachers, students contact devoted to study in a circumscribed area of the program. This include lecturers, tutorial; seminar/workshop period.  Some related course  which  is closely  to it  may be  considered too wide to be, are  usually broken down into or more  course, each  one having it’s own designated  number of credit hours.

DOWNLOAD COMPLETE WORK

DISCLAIMER: All project works, files and documents posted on this website, eProjectTopics.com are the property/copyright of their respective owners. They are for research reference/guidance purposes only and some of the works may be crowd-sourced. Please don’t submit someone’s work as your own to avoid plagiarism and its consequences. Use it as a reference/citation/guidance purpose only and not copy the work word for word (verbatim). The paper should be used as a guide or framework for your own paper. The contents of this paper should be able to help you in generating new ideas and thoughts for your own study. eProjectTopics.com is a repository of research works where works are uploaded for research guidance. Our aim of providing this work is to help you eradicate the stress of going from one school library to another in search of research materials. This is a legal service because all tertiary institutions permit their students to read previous works, projects, books, articles, journals or papers while developing their own works. This is where the need for literature review comes in. “What a good artist understands is that nothing comes from nowhere. The paid subscription on eProjectTopics.com is a means by which the website is maintained to support Open Education. If you see your work posted here by any means, and you want it to be removed/credited, please contact us with the web address link to the work. We will reply to and honour every request. Please notice it may take up to 24 – 48 hours to process your request.

WeCreativez WhatsApp Support
Administrator (Online)
Hello and welcome. I am online and ready to help you via WhatsApp chat. Let me know if you need my assistance.